INDEPENDENT. MRICS. INSTRUMENTED

When the cause hasn’t been found.

Independent damp and defect investigations for problems nobody has solved, and for claims declined on a surface meter reading. Measured, evidenced — and I never sell the cure.

Jonathan Durndell MRICS. 24 years in building pathology, covering Milton Keynes, Oxford and the counties between.

Moisture meter showing a high comparative reading on a damp plastered wall
Moisture meter showing a high comparative reading on a damp plastered wall

Problems I’m called in for

  • A floor that's lifting, staining or won't dry out.

  • Damp that's been treated and come back.

  • Two contractors, two different answers.

  • Mould round new windows and doors.

  • A claim or dispute that needs independent evidence.

  • Insulation that isn't doing its job.

Specialist tests

These are the tests that settle a difficult problem.

Tramex moisture meter reading 91% relative humidity from an in-situ probe sealed into a concrete slab

RH probes and hood tests

In-situ RH probes and hood tests to BS8203. How wet the slab is, how far it has spread, and when it's fit for a new floor.

Floors >

Thermal image of a cold wall and ceiling corner at 14.6°C, a thermal bridge where condensation and mould form

Thermal imaging and fRsi

Thermal imaging finds the cold spot. A contact thermometer proves it. The fRsi test shows whether a reveal meets the design standard.

Thermal >

Endoscope view inside a sub-floor void, showing the underside of the floor above damp, debris-covered ground

Endoscope inspection

Cavities, voids, wall ties and cavity barriers, inspected by endoscope through a small drilled hole. What was actually built, not what the drawings say.

Cavities >

Speedy carbide moisture meter reading 3.2% for a concrete sample taken from a kitchen floor slab

Carbide testing

Carbide testing of drilled samples from walls and floors. It settles whether masonry is actually wet, or whether salts are fooling the meter.

Walls >

Measured, not guessed

A surface meter shows the pattern. I go on to measure what’s causing it: thermal imaging with surface humidity mapping, contact surface temperatures, in-situ RH testing of floors, carbide moisture content of drilled samples, salts analysis and endoscope inspection. I use what the building needs, and the report shows the evidence.

See how an investigation works >

Who I work for

Declined insurance claims

Your claim turned down on a surface meter reading. Carbide testing and in-situ probes measure what the meter only indicated.

Declined claims >

Loss assessors

Cause-of-damage evidence on live claims, and a desktop review that tells you whether a case is worth running.

For assessors >

Solicitors and disputes

New-build defects, ombudsman cases and litigation. Reports written to be relied on by either side, or jointly.

Disputes >

Commercial and managing agents

Offices, healthcare, education and residential blocks. Diagnosed without disruption.

Disputes >

Why independent matters

I don’t carry out repairs, sell products or take commission.

My only output is the evidence: what the readings show, the most likely cause, and the repairs that follow.

One surveyor, named and accountable.

Jonathan Durndell MRICS carries out every inspection and writes every report personally.

I investigate a specific problem. I don’t carry out snagging, pre-purchase damp surveys or remedial works. Every instruction is quoted on scope.

Professional indemnity insurance held. A conflict check before every instruction.

Jonathan Durndell MRICS, Chartered Building Surveyor

Tell me what the problem is.

What’s been tried, who else is involved, and what the report needs to support. I’ll come back with a fixed fee.